[lets go africa]

Originally Posted by Nove.. (View Original Post)

anyone know what the long and thin markers are in this flick?
ive seen them so much, just aint got a clue what they are

Ultrawide markers.

[injury]

... and you cant get them anymore unless you can track someone down with them.

[OnTheRaills]

FUCK THIS SITE IS CONFUSING SOMETIMES THE NEWEST POST IS ON THE FRONT PAGE AND SOME ON THE BACK SORRY MODS OR WHATEVER

[Hullucination]

I've always been fond of pilot markers

[marwa89]

2 things,
nice homemade mop mix/body recipe-
you will need-
-One bingo dabber, (the long squeezy kind)
-one bottle of acrylic paint(any colour will do)
-a can of either white or black spray paint (to tint colour to your liking and for hold)
-a screwdriver
-brake fluid
-a bit of paint thinner

take the top off the bingo dabber and drain the shitty dollar store ink (or keep it whatever floats your boat) then with the screwdriver take out the spring in the nib.منتديات اشهار

fill that shit 2/6 with your acrilic paint
then 1/6 brake fluid اشهار منتديات
then 1/6 of the white or black paint
then thin it with your thinner, you can do 2/6 or 1/6 and add another sixth of paint its up to you.اشهار المواقع
and then close it all up and electrical tape that piece
youve got a nice drippy and custom coloured mop! dont be afraid to mix some colours but if you dont know what your doing look at a coloor wheel first :P

NEXT QUESTION!شركة للتسويق

I recently got a GROG metalhead marker (similar to a dalo but) التسويق الكتروني)
has anyone tried putting tremclad bucket paint in here? looks like it would work.
if not what are some custom fills that work well with a metal tipped marker?

thanks, -Ceper0ne

[sexcauldron]

Put this in the blackbook markers thread, but figured it should go here as well: http://wednesdaysheroes.com/wp-conte...rkerguide3.pdf

[TwistedDrips]

Mio Mop
What you need:
-mio or crystal light water enhancer
-felt from chalkboard eraser
-scissors
-hot glue & gun or lighter
-electrical tape
-paint/ink or your choice

Where to start:
First decide which body type you will use. You can grab these at any supermarket.





Once you have emptied it, open it up by removing the rapper and twisting the cap 90* then pop off the top.

Using scissors, poke out the center of the cap.

Stick your scissors through the hole again and turn them untill you have whittled away the plastic. remove plastic until the red line.




Now, remove the tiny plastic support at the top of the cap. The cap should now look like this:




Now, place hot glue around the rim of the very top cap on hinges and hold it closed. once sealed, wrap around the seam with electrical tape. Shortly hold the wrapped cap over a lighter just until the glue is soft enough to form by pushing through the tape. MAKE SURE YOU DON'T MELT TAPE. your cap should now be airtight.

Now for the nib. I used a 2 inch strip of felt, folded in quarters as my nib. To prevent the nib from being pushed into the bottle, i used a small piece of steel wire to bridge the opening.


Before you push the nib in, fill the body with 2/3 - 3/4 of the paint or ink of your choice.




Now you have a finished mop. Be careful with this as squeezing can pop out the nib if the paint is to thick or to thin and it will pour all over. ALWAYS CARRY IN A PLASTIC BAG!!